Production process monitoring and post-production strain measurement on a full-size carbon-fibre composite aircraft tail cone assembly using embedded optical fibre sensors

Multiplexed optical fibre sensors were embedded into a carbon-fibre-reinforced-preform during the industrial production of a full-sized, one-piece tail cone assembly for a regional jet aircraft. Optical fibre Fresnel sensors monitored both the infusion of the resin, via measurement of the refractive index-dependent attenuation in the reflected light signal, and the degree of cure of the resin, via measurement of the chemical cure reaction-dependent change in refractive index. The resin cure was also monitored by optical fibre Bragg gratings (FBGs) fabricated in high linearly birefringent optical fibre, which measured through-thickness strain development, while FBGs in standard single mode optical fibre measured longitudinal strain development. The magnitudes and profiles of the transverse and longitudinal strains developed during the curing process were consistent across different locations on the tail cone. Typical transverse and longitudinal strains, related to cure reaction-induced shrinkage, were −1500 ± 17 μepsilon and −500 ± 5 μepsilon, respectively. Post-production, the same embedded FBG sensors were used subsequently to monitor structural strains when the tail cone was subjected to vacuum pressure loading. The longitudinal strains measured using the embedded FBG sensors were generally in good agreement with the longitudinal strains measured by the surface-bonded resistance foil strain gauge (RFSG) sensors, both qualitatively and quantitatively. The in-plane transverse and circumferential strains, oriented collinearly, were measured by the embedded FBGs and appropriately oriented surface-bonded RFSG sensors, respectively, and were, qualitatively, in good agreement.